RECOMMENDED PRODUCT - MOT APPROVED ASPHALT AND TARMAC JOINTING AND REPAIR TAPE 
LOWEST WORLDWIDE PRICE - 10 METRE ROLLS OF STICK-DOWN & BURN-ON OVERBANDING FROM ONLY £1.27 PER METRE !! Tarmac Overbanding Tape, burn-on to seal re-instatement works and repair cracks, torch-on application prevents the ingress of water and extends the life of the repair without the time needed to melt pots of bitumen. High quality bitumin overbanding, Choose from 30mm, 40mm or extra wide 50mm open to traffic in 10 minutes INSTRUCTIONS - Sweep the area clean from dust and water, (apply torch beforehand to dry any wet areas) stick tape across the joint removing the separation layer as you go. Lightly torch over the tape to melt it into the jointed line, (kiln dried sand or grit can be sprinkled onto the hot tar joint if additional "non-slip" is needed), The joint will then be waterproof and
welded" together for a long lasting repair. Melts quickly, faster than other brands, uses less gas and seeps into the join more easily to improve the "weld" and dries harder & stronger in about 10 mins......... Can also be stuck upright to the cut edge to guarantee a sealed joint. This tape is supplied in 10 meters long rolls (most other brands are only 5m long x 35mm wide) OUR 40mm wide  is the best for long trench reinstatements and is trafficable within a few minutes after completion, AND IT'S THE LOWEST WORLDWIDE PRICE PER METRE. A polymer modified bituminous strip for use as an instant waterproof overbanding seal for small cracks or reinstatement joints up to 5mm wide. For use on both road pavements and secondary roads. The application of the tape prevents the ingress of water which causes cracking and severe fretting leading to the eventual breakdown of the asphalt pavement. The skid resistance can be increased by covering the tape with granite dust or kiln dried sand during torch on procedure, providing a surface value similar to that of the existing road surface.